I started a new commission a few weeks ago. However, the first 3 weeks have Baan digging the stone out from under a bunch of other stone, then flattening the bottom so I could stand it up. Last night, I finally got the piece stood up and started carving.

The block started out around 3000 pounds. I took a little off of it to get the bottom flat. Now I will be removing a bunch of weight. To start I used feathers and wedges to split the corners off the top to begin shaping the roundness of the head. I left a lot more than a typical head as this piece will have foliage rather than hair. It is going to compliment a piece that I did several years ago for the same folks. 

After I got the corners knocked off, I used a diamond saw to remove basic material. I cut kerfs in the stone then use a hammer drill to quickly remove the pieces to the score line, I used to just start carving with my air hammer. If I were to still work that way, this project would take aver a year to complete. Hy hope is that this will be completed by the end of the year.

Once I remove a lot of the basic material, I alternate between the air hammer and the diamond blade to rough in the shapes. The air hammer allows me to start creating the forms and then I can come back with the saw to remove any waste. In the video below, you will see the progress I made in just a few hours.